FlipBit™ Bolt Extractor Set
Regular price
$45.00
Sale price
$29.99
WHY THE CANUCKTURBO FLIPBIT?
Built for the bolt that snaps at the worst possible moment. One bit, two jobs, zero welding.
Two Tools, One Bit
A left-hand drill tip on one end, a reverse-thread extractor on the other. Drill, flip it and keep going.
Hardened To Bite
HSS 4341 steel hardened to 63 HRC grips deep into rusted, stripped and snapped hardware.
Fits Your Drill
The hex body locks into any standard drill chuck. Set it to reverse, run it slow, done.
Always Ready
Five sizes in a compact hard case that lives in your truck, toolbox or tool belt.
ONE BIT. ENDLESS RESCUES.
From the engine bay to the back deck, the FlipBit gets out the screws and bolts that just won't budge.
CARS & TRUCKS
Snapped exhaust studs, seized manifold bolts and rusty brackets. Back them out without tearing the whole job apart.
BUILT FOR CANADIAN WINTERS
Snowblower and mower bolts rusted solid after a season outside. Get them out and get back to clearing the driveway.
DECKS & FENCES
Stripped deck screws and rusted fence hardware come out clean, so you replace the board, not the whole deck.
ATVS & SLEDS
Mud, salt and vibration seize everything. FlipBit handles the rounded and rusted bolts on your ride.
AROUND THE HOUSE
Stripped cabinet hinge screws, door hardware and furniture screws. Small bits for the small jobs too.
TRAILERS & FARM GEAR
Trailer frames, hitches and equipment that sit outside year-round. Rusted bolts don't stand a chance.
Why Buy From Us
We're proudly Canadian business based in Quebec, trusted by over 20,000 customers.
Fast shipping, real customer support and quality gear that actually works.
Frequently Asked
×Your order will be shipped within 1 to 2 business days. Most orders are delivered between 5 to 9 business days for our free standard shipping via Canada Post.
Every FlipBit set comes with our 90-day money-back guarantee. If it's not for you, reach out to our support team for a full refund.
Pick the bit that matches your fastener and chuck it in with the drill tip out. Set your drill to reverse and drill a small pilot hole in the center of the screw or bolt. Then flip the bit, chuck the extractor end and keep running in reverse at low speed. The reverse thread bites in and backs the fastener out.
The set includes 5 sizes, #0 to #4. Together they cover #3 to #24 screws and bolts from 5/32" (4 mm) up to 3/8" (10 mm). Check the size guide in the photos to pick the right one.
Yes. The hex body fits any standard drill chuck. Your drill just needs a reverse setting, which almost every corded and cordless drill has.
No. Each FlipBit is the drill bit and the extractor in one, so there's nothing else to buy and no nut to weld on.
Spray penetrating oil and give it a few minutes to soak in. Keep the drill straight, run it slow and use steady pressure. A center punch mark helps the drill tip start right in the middle.
